bergoz Instrumentation
Table-top test kit ref. TEST-KIT
includes 2 boards:
- Rear connector board with SMA inputs and BNC outputs
Supports MX-BPM, LR-BPM and BB-BPM.
- Front connector board with BNC outputs
Various versions for MX- LR- and BB-BPM
includes 2 boards:
- Rear connector board with SMA inputs and BNC outputs
Supports MX-BPM, LR-BPM and BB-BPM.
- Front connector board with BNC outputs
Various versions for MX- LR- and BB-BPM
Conductive RF-shielded chassis BPM-RFC
Front view
fully equipped : BPM-RFC/16
Rear view
fully equipped BPM-RFC/16
Technical data
- Up to 16 BPM stations
- Stations are compatible with any mix of MX-BPM, LR-BPM, BB-BPM..
- Can be partially equipped (less than 16 stations)
- Two power supplies (one cold spare)
- Mains supply 98...265 Vac, 50/60 Hz
- One test station with 4 asymmetric RF inputs to simulate a known beam offset
- SMA jacks for RF beam pickup inputs
- DB15 female output connector per BPM station
- DB9 male connector for control inputs, common to all stations
- Up to 16 BPM stations
- Stations are compatible with any mix of MX-BPM, LR-BPM, BB-BPM..
- Can be partially equipped (less than 16 stations)
- Two power supplies (one cold spare)
- Mains supply 98...265 Vac, 50/60 Hz
- One test station with 4 asymmetric RF inputs to simulate a known beam offset
- SMA jacks for RF beam pickup inputs
- DB15 female output connector per BPM station
- DB9 male connector for control inputs, common to all stations
In-factory expansion of partially equipped chassis
is possible. Order code BPM-RFC/UP per
station.
Table-top test kit BPM-KIT for test and
adjustments
BPM module extender BPM-XTD
BPM module is installed on module extender.
Includes RF coaxial inputs.
BPM service boards BPM-SERV/RF and
BPM-SERV/CMD
BPM-SERV/RF features 5 BNC connectors on the front panel. They are connected to the four RF inputs and the Fast Gate input of the rear connector. Very useful to view the RF signals from the pickups, because the SMA cables at rear of chassis cannot easily be disconnected.
BPM-SERV/CMD features one DB15 and one DB9 connector on front panel directly connected to their corresponding pins on the rear connector. Very useful to feed signals into the readout system, because the DB 15 cables at rear of chassis cannot easily be disconnected. Connectors pinouts are same as those of BPM chassis.
BPM-SERV/RF features 5 BNC connectors on the front panel. They are connected to the four RF inputs and the Fast Gate input of the rear connector. Very useful to view the RF signals from the pickups, because the SMA cables at rear of chassis cannot easily be disconnected.
BPM-SERV/CMD features one DB15 and one DB9 connector on front panel directly connected to their corresponding pins on the rear connector. Very useful to feed signals into the readout system, because the DB 15 cables at rear of chassis cannot easily be disconnected. Connectors pinouts are same as those of BPM chassis.
BPM
RF-chassis partially filled e.g. 13
stations:
BPM-RFC/13
Rear connector board
BPM Accessories
DB9 front board for MX-BPM
DB9 front board for LR-BPM